Constant Temperature Viscosity Baths CT500/518 - 17L - 9726-A15

The CANNON CT-500/518 baths maintain accurate temperature control of ± 0.01°C within the range of 20°C to 100°C, providing the temperature sensitivity required by ASTM D 445 for kinematic viscosity measurements with glass capillary viscometers. Two electric heating elements inside the bath rapidly heat the medium to any desired temperature within the range. A cooling coil, when connected to tap water or a cooling system, permits operation below or slightly above ambient temperature. A special selector switch on the front panel facilitates rapid setting of ten popular temperatures for kinematic viscosity determinations. Temperatures which may be selected with this switch are 20, 25, 30, 40, 50, 60, 70, 80, 90, and 100°C. After the switch has been set, the bath will equilibrate to within a fraction of one degree of the desired temperature. A fine tuning control then allows temperature adjustment to within ± 0.01°C of the target temperature. By switching to the “variable” setting on the front panel, any temperature within the operating range can be obtained. A solid-state control circuit provides proportional control of temperature. The sensing element for the control circuit is a stainless steel-encased thermistor. A motor-driven stirrer ensures a uniform temperature throughout the bath. The entire electrical control system is located in a convenient drawer, mounted on glides for easy access if adjustment or repair is necessary. The CT-500 bath chamber is a cylindrical clear glass vessel 305mm (12 inch) in diameter and 305mm (12 inch) high. The CT-518 bath chamber is a full 457mm (18 inch) high. A PTFE-coated stainless steel baffle located in the center of the bath provides a plain reflective background to aid in viewing instruments.